Zenoah TWIN GT80 Instruction Manual download pdf (Page 22)

Step 4. Fit the wheel pants over the axle and align with the

landing gear as shown. With the wheel pants properly aligned,

mark the mounting hole position through the landing gear on the

wheel pants using a pen.

Step 5. Remove the wheel pants and carefully drill a

/8" hole

through the pants at the marked hole.

Step 6. Install the 4-40 blind nut from inside the wheel pants as

shown. Later we will fully seat the blind nut into the plywood

when installing the pants on the landing gear.

Step 7. Install onto the axle in the following order: wheel pant,

/16" collar, wheel, then another

/16" collar. It will be necessary

to fit the parts inside the wheel pant and slide them onto the axle.

Step 8. Fasten the wheel pants in place using 4-40 x

/8"

screws with washer and split washer through the landing gear

and into the blind nut in the wheel pants. Use Blue Locktite

and

securely tighten the screws to properly seat the blind nuts.

Section 8: Installing the Landing Gear

CONTINUED

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

No comments

Zenoah TWIN GT80 Instruction Manual Page 22