Zenoah TWIN GT80 Instruction Manual download pdf (Page 30)

Step 1. Glue a 1/3 scale pilot in the rear seat area (silicone glue

works good here) and attach the instrument panels. Hangar 9

offers sharp looking Extra Instrument Panels (HAN185) that

replace the decals for a scale look.

• Hatch (HAN1210)

• Canopy (HAN1209)

• (2) 4-40 x

/4" Screws with Split Washers and

#4 Washers (HAN1214)

• Decals for instrument panels or optional

Hangar 9 Scale Panels (HAN185)

Not Included

• 1/3 Scale Pilot (HAN8265)

• Scissors

•

/32 hex wrench

• Canopy Glue (Pacer Formula 560 or equivalent)

(PAAPT56)

• Silicon glue (3M caulking)

• Masking tape

Parts Needed Tools and Adhesives Needed

Section 12: Hatch Assembly

Section 11: Mounting the Engine and Cowl

CONTINUED

Step 5. Optional muffler BIS07163 is recommended. Install

the muffler.

Step 6. Using a Moto-tool with a cut-off wheel and a drum

sander, cut an air outlet in the bottom of the cowl as shown. The

approximate size should be 5" x 5". It may also be necessary to

cut out an area for the mufflers to exit, depending on the mufflers

and engine you use.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

No comments

Zenoah TWIN GT80 Instruction Manual Page 30