Zenoah TWIN GT80 Instruction Manual download pdf (Page 15)

Non-Computer Radio(CONTINUED)

Step 2. Install the servos in the fuselage tail section with the

output shaft to the rear as shown in the photo. If using a non-

computer radio, be sure to install one of the servos with the

Y-harness attached in the top opening (elevator) and the other

servo with the Y-harness attached in the bottom opening

(rudder). Install the other servos in the opposite side of the

fuselage being sure to connect the servo to the other open

connector of the respective Y-harnesses. Don’t forget to tape and

knot the connectors. One of the elevator servos must be a

reversed servo.

Step 3. Using the screws included with the servos, fasten the

servos in place. You may find it helpful to drill a

/16" pilot hole

before installing the screws.

Section 5:

Installing the Rudder and Elevator Servos

CONTINUED

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

No comments

Zenoah TWIN GT80 Instruction Manual Page 15