#3: Install the billet flywheel adaptor (Part#6) onto
flywheel and tighten it with supply bolts (Part#27).
#4: Install the back engine mount back on with
original bolts.
#5: Match the 4 bolts on TS760-Marine Kit onto the
4 pull starter installation thread holes.
#6: Tighten the 4 bolts by using a short head 4mm
hex wrench to complete the installation.
Carburetor Side Installation Completed! You can also rotation the TS760-Marine Kit at 90
degree and install it at exhaust side as picture
shown above.
Comments to this Manuals