Zenoah G290PUM User Manual download pdf (Page 9)

#1: Unscrew the belt wheel cover. #2: Loosen the motor bolts, and take out the belt.

#3: Release the clip from the gear shaft. #4: Unscrew the bolt from the main belt wheel.

#5: Take out the belt wheel, and loosen the 4 bolts as

shown in the picture above.

#6: Now, you can adjust the motor position to by

rotating the plate. Then, tighten the 4 bolts after the

position is targeted. And install everything back on.

Note: The 4 adjusting bolts didn’t apply with loctite in factory, so, after you set up the preferred position,

apply little loctite on each bolts in order to secure the plate better in place.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Zenoah G290PUM User Manual Page 9