Zenoah G290PUM User Manual download pdf (Page 5)

Adjustment”, then click on the third channel switch to move the radio to the “Right

Forward” setting. Adjust that to 0% which will enable you to turn off the R-One

device when your gas engine is started. If this rate is set at any higher than 0%, when

you turn off the third channel switch the electric motor will spin counter-rotation

which is not needed for your starter system.

Before you connect the LIPO battery to the R-One device, make sure the Third

Channel setting is at the “Turn Off” position which should be at 0% of the “Right

Forward” EPA setting. Otherwise, when you turn on the power switch of the R-One

device, the electric motor will start running and you might not be ready for engine

starting at that moment.

Note: If you use the R-one on a counter-rotation engine, then set the “Left

Forward” at 0% and “Right Forward” at 120%.

Why only three seconds operation each time?

The peak electric current from the battery to the motor is achieved in those first few

seconds of operation. That delivers the maximum torque and rpm of the motor. After

three seconds, the motor’s power reduces slightly. Pausing after three seconds if the

engine hasn’t started means that, when you try again, you will again have maximum

power for the starter system. If the engine is warm, you will only need one second of

starter operation to start the engine.

Installation of TS760-Marine

TS760-Marine E-Starter will work for about all brands marine engines and difference

version engines that is available on the market today, Such as Arrow Shark, Zenoah,

CY, RCMK, Quick Draw, all clone version Zenoah alike engine etc with all formats of

Side exhaust, rear exhaust, twin inline or counter-rotation versions.

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Zenoah G290PUM User Manual Page 5