Zenoah BCZ2602DL Owner's Manual download pdf (Page 11)

GB-11

BCZ2602DL

ADJUSTING THROTTLE CABLE

• The normal play is 1 or 2 mm when measured at the

carburetor side end. Readjust with the cable adjuster

as required.

(1)

(1) Cable adjuster

ADJUSTING IDLING SPEED

(1) Idle adjusting screw

1. When the engine tends to stop frequently at idling

mode, turn the adjusting screw clockwise.

2. When the cutting head keeps rotating after releasing

the trigger, turn the adjusting screw counter-clockwise.

NOTE

•Warm up the engine before adjusting the idling speed.

CUTTER APPLICATION CHART

• Replace by a suitable recommended cutting attach-

ment according to the object to be cut.

• When replacing blade always be sure to use products

which have been certified by KOMATSU ZENOAH.

WARNING

• When sharpening, removing, or reattaching the blade,

be sure to wear thick, sturdy gloves and use only

proper tools and equipment to prevent injury.

(1)

8. Operation

.04 in

(1 ~ 2 mm)

METAL BLADE USAGE

1. Check the bolt to fasten the blade and be sure the

bolt has no fault, and no abrasion.

2. Be sure that the blade and the holder have been fas-

tened according to instruction and the blade turns

smoothly without abnormal noise.

WARNING

• The rotating parts fastened incorrectly may

cause serious accident to the operator.

• Make sure that the blade is not bent,

warped, cracked, broken or damaged.

• If you find any error to the blade, discard it

and change new one which is certified by

KOMATSU ZENOAH.

• By using the shoulder strap, hang the unit on your

right side. Adjust the strap length so that the cutting

head may become parallel to the ground.

WARNING

• Make sure to use shoulder strap and debris

guard. If not, it is vary dangerous when you

slip or lose your balance.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zenoah BCZ2602DL Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Grass trimmers Zenoah BCZ2602DL