Zenoah BCZ2602DL Owner's Manual download pdf (Page 10)

GB-10

BCZ2602DL

STARTING ENGINE

WARNING

The cutting head will start rotating upon the engine

starts.

1. Feed fuel into the fuel tank and tighten the cap se-

curely.

2. Rest the unit on a flat, firm place. Keep the cutting

head off the ground and clear of surrounding objects,

as it will start rotating upon starting of the engine.

3. Push the primer pump several times until overflown

fuel flows out in the clear tube.

4. Move the choke lever to the closed position.

5. Set the ignition switch to the “I” position. Set the throttle

lever to the start position (1 → 2 → 3).

Place the unit on a flat, firm place.

Keep the cutting head clear of everything around it.

6. While holding the unit firmly, pull out the starter rope

quickly until engine fires.

WARNING

The product is equipped with a centrifugal clutch

mechanism, so the cutting attachment begins to ro-

tate as soon as the engine is started by putting the

throttle into the start position. When starting the en-

gine, place the product onto the ground in a flat clear

area and hold it firmly in place so as to ensure that

neither the cutting part nor the throttle come into con-

tact with any obstacle when the engine starts.

IMPORTANT

• Avoid pulling the rope to its end or returning it by re-

leasing the knob. Such actions can cause starter fail-

ures.

7. Move the choke lever downward to open the choke.

And restart engine.

8. Allow the engine to warm up for a several minutes

before starting operation.

NOTE

1. When restarting the engine immediately after stop-

ping it, leave the choke open.

2. Overchoking can make the engine hard to start due

to excess fuel. When the engine failed to start after

several attempts, open the choke and repeat pulling

the rope, or remove the spark plug and dry it.

STOPPING ENGINE

1. Release the throttle lever and run the engine for half

a minute.

2. Shift the ignition switch to the STOP position.

IMPORTANT

• Except for an emergency, avoid stopping the engine

while pulling the throttle lever.

8. Operation

Stop

Start

3. Ignition switch

Stop

Start

Ignition switch

(1)

(2)

(3)

(1) choke lever

(2) close

(3) open

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zenoah BCZ2602DL Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Grass trimmers Zenoah BCZ2602DL