Zenoah G2500 User Manual

G2500 / G2500 OPSGB-1GBG2500G2500 OPS (One-Push-Start)CHAIN SAWSOWNER’S MANUALGB848C1B93A1 (704)

G2500 / G2500 OPSGB-10 NOTE NOTE4. Pour in the rest of gasoline and agitate again for atleast one minute. As some oils may be difficult toagitate depe

G2500 / G2500 OPSGB-11GBIt is very dangerous to run a chainsaw that mounts brokenparts or lacks any parts.Before starting engine, make sure that all t

G2500 / G2500 OPSGB-12• When pulling out the rope, large clanging is produced.With this clanging, stop pulling out the rope at once.This sound notif

G2500 / G2500 OPSGB-13GB • When the brake operates, release the throttle leverto slow down the engine speed. Continuous opera-tion with the brake enga

G2500 / G2500 OPSGB-14A log lying on the groundSaw down halfway, then roll the log over and cut fromthe opposite side.A log hanging off the groundIn a

G2500 / G2500 OPSGB-15GBWhen returning the filter, use a pinch not to be folded the suc-tion pipe.3. Oil filter1. With a wire hook, take out the oil f

G2500 / G2500 OPSGB-168. Recoil Starter• For recoil maintenance, when attaching or detaching thestarter of One-push-start model, the select lever

G2500 / G2500 OPSGB-17GBside of a cutter. If a gap is observed between them,the rail is normal. Otherwise, the bar rail is worn.Such a bar needs to be

G2500 / G2500 OPSGB-1811. SpecificationsCutting head:<Sprocket bar>Sprocket: ...

G2500 / G2500 OPSGB-19GB12. Limited warrantyShould any failure occur on the product under normaloperating conditions within the applicable warranty pe

G2500 / G2500 OPSGB-2EXPLANATION OF SYMBOLS AND SAFETY WARNINGSRead operator's instructionbook before operating thismachine.Wear head, eye and ea

G2500 / G2500 OPSGB-3GBContents1. For Safe Operation ... 42. Explanation of Symbols on

G2500 / G2500 OPSGB-410. Always hold the chain saw firmlywith both hands when the engineis running. Use a firm grip withthumb and fingers encircling t

G2500 / G2500 OPSGB-5GBKICKBACK SAFETY PRECAU-TIONS FOR CHAIN SAW US-ERS WARNING• Kickback may occur when thenose or tip of the guide bartouches an

G2500 / G2500 OPSGB-6WORKING WITH TREE SERVICE CHAIN-SAWSFROM A ROPE AND HARNESSThis chapter sets out working practices to reduce therisk of injury fr

G2500 / G2500 OPSGB-7GBGaining a good footing at the working position can beassisted by use of a temporary foot stirrup created froman endless sling.S

G2500 / G2500 OPSGB-82. Explanation of Symbols on the MachineThe port to refuel “MIX GASOLINE”Position: Fuel capThe port to top up chain oilPosition:

G2500 / G2500 OPSGB-9GBOpen the box and install the guide bar and the sawchain on the power unit as follows:The saw chain has very sharp edges. Use th