Zenoah EB7000 User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
GB-13
EBZ4800 / EB7000
G
B
PROCEDURES TO BE PERFORMED AFTER EV-
ERY 100 HOURS OF USE
1. Remove the muffler, insert a screwdriver into the vent,
and wipe away any carbon buildup. Wipe away any
carbon buildup on the muffler exhaust vent and cylin-
der exhaust port at the same time.
2. Tighten all screws, bolts, and fittings.
AIR INLET NET
IMPORTANT
•Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
Note that failure to remove any such obstacles may
result in the engine becoming overheated and dam-
aged.
(1)
(1)Net
WARNING
Never use the blower without the net of the blower.
Before each use, check that the net is attached in
place and is free from any damage.
9. Maintenance
SHOULDER STRAP
If the shoulder strap is damaged it may break during
use, thus causing the product to fall and resulting in
personal injury. Follow the instructions below to replace
the shoulder strap with new one.
1. Pass the upper end of the strap through the hanger,
marking the FLAPPED SIDE OUTSIDE.
2. Put the end of the strap through the ring on the strap,
and then push the ring toward the hanger as close as
possible.
WARNING
The flap on the end of the strap works as a stop-
per. Never install the strap with the flapped side
inside, or the unit may fall from the operation,
which could result in injury to the operator and/or
damage to the unit.
Do not apply liquid type screw lock glue on screws
or bolts used to fix plastics components. Adher-
ence of this type of glue may cause cracks on plas-
tics and end up with the breakage.
(1)Ring
(2)Flapped side
11. Disposal
When disposing your machine, fuel or oil for the machine,
be sure to allow your local regulations.
10. Storage
BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb until it be-
comes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle
oil into the cylider. Crank the engine several times and
install the spark plug.
3. Store unit in a dry, dust free place, out of the reach of
children.
Page view 12
1 2 ... 8 9 10 11 12 13 14

Comments to this Manuals

No comments