Zenoah GZ400 User Manual download pdf (Page 28)

It is very dangerous to run a chain saw that mounts

broken parts or lacks any parts.

Before starting engine, make sure that all the parts

including bar and chain are installed properly.

■ STARTING THE ENGINE

1. Fill fuel and chain oil tanks respectively, and tighten

the caps securely. (F8-1)

2. Set the switch to “I” position. (F8-2)

(1) Chain oil

(2) Fuel

(3) Switch

3. Continuously push the primer until fuel comes in the

bulb. (F8-3)

(4) Primer

4. Pull the choke knob all the way out to FULL CHOKE

position. (F8-4)

(5) Choke knob (FULL CHOKE Position)

(a) RUN (b) HALF CHOKE (c) FULL CHOKE

5. While holding the saw unit securely on the ground,

pull the starter grip until the engine attempts to start,

but no more than 5 times. (F8-5)

Do not start the engine while the chain saw hangs

in one hand. The saw chain may touch your body.

This in very dangerous.

6. Push the choke knob to HALF CHOKE position.

7. Pull starter grip until engine runs.

Allow the saw to run in this position 15~30 seconds,

depending upon the temperature.

NOTE

WARNING

(5)

(a)

(b)

(c)

(4)

F8-1

F8-2

F8-3

F8-4

F8-5

8. Operation

English

KZA_GZ400 07.4.20 5:10 PM ページ 28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 71 72

Comments to this Manuals

No comments

Zenoah GZ400 User Manual Page 28

Comments to this Manuals

Related products and manuals for Power chainsaws Zenoah GZ400