Zenoah G6200 User Manual Page 1

G6200GBGB-1G6200OWNER’S MANUALCHAIN SAWGB848C9F93A0 (807)

G6200GB-10 ICING PREVENTION SYSTEMThis system prevents icing of the carburetor which some-times happen while sawing in winter.When your saw has stop

G6200GBGB-116. Sawing• Before proceeding to your job,read the section “For Safe Op-eration”. It is recommended tofirst practice sawing easy logs.This

G6200GB-12A log lying on the groundSaw down halfway, then roll the log over and cut fromthe opposite side.A log hanging off the groundIn area A, saw u

G6200GBGB-13 PERIODICAL SERVICE POINTS1. Cylinder finsDust clogging between the cylinder fins will cause overheat-ing of the engine. Periodically che

G6200GB-14 WARNING• This saw is equipped with one of the following lowkickback bar/chain combinations:Zenoah Part NumberBar Size Guide Bar Saw Chain1

G6200GBGB-159. Troubleshooting GuideCase 1. Starting failure WARNING• Make sure the icing prevention system is not working.11. SpecificationsPower u

G6200GB-16Limited warrantyShould any failure occur on the product under normaloperating conditions within the applicable warranty pe-riod, the failed

G6200GB-2EXPLANATION OF SYMBOLS AND SAFETY WARNINGSRead operator's instructionbook before operating thismachine.Wear head, eye and earprotection.

G6200GBGB-3Contents1. For Safe Operation ... 42. Explanation of Symbols on the Machine

G6200GB-410. Keep all parts of your body away fromthe saw chain when the engine is run-ning.11. Before you start the engine, makesure the saw chain is

G6200GBGB-5(3) Make certain that the area in whichyou are cutting is free from obstruc-tions. Do not let the nose of the guidebar contact a log, branc

G6200GB-62. Explanation of Symbols on the Machine WARNING• For safe operation and maintenance, symbols are carved in relief on the machine.According

G6200GBGB-75. Fit the chain cover to the power unit and fasten thenuts to finger tightness.6. While holding up the tip of the bar, adjust the chainten

G6200GB-84. Fuel and Chain Oil FUEL WARNING• Gasoline is very flammable. Avoid smoking orbringing any flame or sparks near fuel. Make sureto stop t

G6200GBGB-97. Allow the engine to warm up with the throttle leverpulled slightly. WARNING•Keep clear of the saw chain as it will start rotatingupon s