Zenoah G3300 Owner's Manual download pdf (Page 4)

G3300

GB-4

1. For safe operation

WARNING

This chainsaw has been especially designed for tree

maintenance and should therefore only be used by

trained operators when working on trees.

1. Never operate a chain saw when you

are fatigued, ill, or upset, or under the

influence of medication that may

make you drowsy, or if you are under

the influence of alcohol or drugs.

2. Use safety footwear, snug fitting

clothing and eye, hearing and head

protection devices.

Use the vibration-proof glove.

3. Keep the saw chain sharp and the

saw, including the AV system, well

maintained. A dull chain will increase

cutting time, and pressing a dull

chain through wood will increase the

vibrations transmitted to your hands.

A saw with loose components or with

damaged or worn AV buffers will also

tend to have higher vibration levels.

4. Always use caution when handling

fuel. Wipe up all spills and then move

the chain saw at least 3 m from the

fueling point before starting the en-

gine.

5. Eliminate all sources of sparks or

flame (i.e. smoking, open flames, or

work that can cause sparks) in the

areas where fuel is mixed, poured,

or stored.

6. Do not smoke while handling fuel or

while operating the chain saw.

7. Do not allow other persons to be near

the chain saw when starting or cut-

ting. Keep bystanders and animals

out of the work area. Children, pets

and bystanders should be a minimum

of 10 m away when you start or oper-

ate the chain saw.

8. Never start cutting until you have a

clear work area, secure footing, and

a planned retreat path from the fall-

ing tree.

9. Always hold the chain saw firmly with

both hands when the engine is run-

ning. Use a firm grip with thumb and

fingers encircling the chain saw

handles.

10. Keep all parts of your body away from

the saw chain when the engine is run-

ning.

11. Before you start the engine, make

sure the saw chain is not contacting

anything.

12. Always carry the chain saw with the

engine stopped, the guide bar and

saw chain to the rear, and the muffler

away from your body.

13. Always inspect the chain saw before

each use for worn, Ioose, or dam-

aged parts. Never operate a chain

saw that is damaged, improperly ad-

justed, or is not completely and se-

curely assembled. Be sure that the

saw chain stops moving when the

throttle control trigger is released.

14. All chain saw service, other than the

items listed in the Owner’s Manual,

should be performed by competent

chain saw service personnel. (E.g.,

if improper tools are used to remove

the flywheel, or if an improper tool is

used to hold the flywheel in order to

remove the clutch, structural damage

to the flywheel could occur which

could subsequently cause the fly-

wheel to disintegrate.)

15. Always shut off the engine before

setting it down.

16. Use extreme caution when cutting

small size brush and saplings be-

cause slender material may catch the

saw chain and be whipped toward

you or pull you off balance.

17. When cutting a limb that is under ten-

sion, be alert for spring- back so that

you will not be struck when the ten-

sion in the wood fibers is released.

18. Never cut in high wind, bad weather,

when visibility is poor or in very high

or low temperatures. Always check

the tree for dead branches which

could fall during the felling operation.

19. Keep the handles dry, clean and free

of oil or fuel mixture.

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments