Zenoah HTZ7500 Owner's Manual download pdf (Page 10)

GB-10

HTZ7500 / CHTZ6000 / CHTZ7500

(6)

(5)

(7)

(8)

(7) (6)

(5)

(8)

(5) Stop switch

(6) RUN

(7) STOP

(8) throttle trigger

7. Operation

6. While holding the unit firmly, pull out the starter rope

quickly until engine fires.

[HTZ7500] [CHTZ6000]

[CHTZ7500]

IMPORTANT

•Avoid pulling the rope to its end or returning it by re-

leasing the knob. Such actions can cause starter fail-

ures.

7. Move the choke lever downward to open the choke.

and restart engine.

(2)

(3)

(4)

8. Allow the engine to warm up for a several minutes

before starting opertion.

NOTE

1. When restarting the engine immediately after stop-

ping it, leave the choke open.

2. Overchoking can make the engine hard to start due

to excess fuel. When the engine failed to start after

several attempts, open the choke and repeat pulling

the rope, or remove the spark plug and dry it.

STARTING ENGINE

1. Feed fuel into the fuel tank and tighten the cap se-

curely.

2. Rest the unit on a flat, firm place. Keep the cutting

head off the ground and clear of surrounding objects

as it will start moving upon starting of the engine.

3. Push the primer pump several times until overflown

fuel flows out in the clear tube.

(1)

4. When the engine is cool, move the choke lever to the

closed position.

(2)

(3)

(4)

5. Set the stop switch to the “RUN” position.

Release the throttle trigger and make sure it is fully

back.

(2) choke lever

(3) close

(4) open

(1) primer pump

(2) choke lever

(3) close

(4) open

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Zenoah HTZ7500 Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Grass trimmers Zenoah HTZ7500