Zenoah BK2650DL Owner's Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
GB-8
BK2650DL
6. Set up
INSTALLING THE SHOULDER STRAP
1. Hook the upper part of the shoulder strap at the notch
on the top of the frame and pass it through the buckle
as shown in the Figure, then secure it firmly.
2. Put the hook at the lower part of the shoulder strap in
the strap installing location at the bottom of the frame.
Buckle
Frame
Hook
D-ring
INSTALLING HANDLE
Mount the handle to the shaft tube and clamp it at a
location that the edge of CE label is matched with the
handle.
WARNING
Stop tightening the screws when the gap A be-
comes zero.
CONNECTING THE FLEXIBLE SHAFT AND BK2650DL
1. Remove the retaining bolt (M5 x 10) at the center of
the joint end and loosen the fixing bolt (M5 x 20).
Loosen also the fixing screws (M5 x L20) at two loca-
tions that fix the throttle lever assembly. Be careful
not to drop the nuts.
2. Insert the throttle lever assembly in the main pipe.
3. Push the main pipe in the joint while rotating it gently
to the right and left.
4. Align the retaining screw hole for the joint with the
main pipe hole, screw in the retaining bolt and se-
cure it firmly.
5. Tighten the joint fixing bolt to fix the main pipe se-
curely.
[Tightening torque] 4.9 to 7.8 N-m (0.5 to 0.8 kg-m)
6. Slide the throttle lever assembly toward the joint, screw
in the fixing screw and secure it firmly.
(1) Retaining hole
(2) Main pipe
(3) Cramp screw
(4) Joint
(5) Retaining bolt
CE label
INSTALLING CUTTING HEAD
1. While locking the gear shaft, by inserting the supplied
tool into the upper holder on the gearbox, loosen and
remove the hexagon nut (left-handed).
2. Then screw in the cutting head to the gear shaft over
the holders. Hand-tighten it securely.
DEBRIS GUARD SKIRT FOR LINE HEAD
When using line head, make sure to attach the guard
skirt.
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with head
aparting from the ground when using it.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments